Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Clean soldering iron tips
A weighted cup for brass tip-cleaning wool: stuff the wool into the inner ring and wipe the hot iron tip through it, while the outer moat catches flux crumbs.
Printing notes
40.9 cm³
Volume
50.7 g
Est. weight
1,168
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Smooth a step at a door threshold
A low ramp for a door threshold up to 22 mm high, so robot vacuums, wheeled bins and walkers roll over instead of getting stuck.
Printing notes
185.2 cm³
Volume
229.6 g
Est. weight
260
Triangles
Print as it comes (ramp outline on the bed); print two side by side for a wide door.
MAIN PURPOSE: Display sports medals
Display race and sports medals on the wall: thread each ribbon through a slot so the medals hang in a row under the engraved word.
Printing notes
67.0 cm³
Volume
83.1 g
Est. weight
12,690
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Number tables at events and restaurants
A table number for restaurants, weddings and events: the number stands up on a weighted foot, easy to read from across the room.
Printing notes
14.8 cm³
Volume
18.4 g
Est. weight
3,274
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store vacuum attachments on the wall
Screw the plate to the wall beside a stick vacuum and park its crevice tool, brush and extension on the three pegs. Print it lying flat; on the wall the pegs point straight out.
Printing notes
144.9 cm³
Volume
179.6 g
Est. weight
3,028
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Protect floors under casters
Stops chair and sofa casters rolling and scratching wooden floors: the wheel sits in the inner ring and the grip feet hold the cup still.
Printing notes
20.5 cm³
Volume
25.4 g
Est. weight
1,168
Triangles
Print four in TPU or PETG. Prints as shown on its floor, no supports.
MAIN PURPOSE: Make a skipping rope
Turn any 6-10 mm rope into a skipping rope: thread each end through a handle, tie a knot and pull it back inside; the round grips spin freely in the hand.
Printing notes
25.8 cm³
Volume
32.0 g
Est. weight
848
Triangles
Print two. Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a ball for place kicks
Holds a rugby or American football upright for place kicks on grass or artificial turf: the ball rests in the ring at the right height and angle.
Printing notes
64.9 cm³
Volume
80.5 g
Est. weight
1,008
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Blow soap bubbles
Dip the ring in bubble mixture and wave slowly for big bubbles; the long handle keeps sticky hands clear.
Printing notes
12.0 cm³
Volume
14.9 g
Est. weight
348
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Draw with pavement chalk
Holds a chunky stick of pavement chalk so little hands stay clean and the chalk doesn't snap; push the chalk up as it wears down.
Printing notes
17.9 cm³
Volume
22.2 g
Est. weight
848
Triangles
Prints as shown on its floor, no supports.