Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print one per player. Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Print in a dark colour. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Add 60 cm of cord and two 15 mm beads. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Add 2 mm wire, a buzzer, a 5 mm LED and 2 AA cells. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Prints flat as a plate, no supports.
Print twenty or more. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Add 50 cm of cord and a table-tennis ball. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in PETG for water play. Prints flat as a plate, no supports.