Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in PETG, profile on the bed. Prints as shown on its outline, no supports.
Print in PETG with 100% infill. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.
Print flat in PETG at 100% infill.
Print two in TPU or PETG. Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as it comes; lay it on its long edge beside the stone.
Set the plate thickness (Wall) from 1 to 5 mm and print a set. Prints flat as a plate, no supports.
Prints flat as a plate, no supports.