Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the big oxygen cup red and the two hydrogen cups white, like a school model. Prints as shown on its floor, no supports.
Lay half black and half white paper in each bay, cap gills-down across the join, lid on overnight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Matt light filament shows the spot best. Marks set for about 51 degrees north. Prints as shown on its floor, no supports.
Measure your vial; set the inner size 2 mm larger. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print as it comes (profile on the bed); legs come out solid.
Print as it comes (profile on the bed), 100 % solid.
Print nine, open side up, same settings for equal weight. Prints as shown on its outline, no supports.
Print as it comes (profile on the bed); the rib is solid.
Two 4 mm rods 260 mm long; twenty 20 mm wooden beads. Prints as shown on its floor, no supports.
Print open side down; 8 mm and 6 mm dowels. Prints as shown on its floor, no supports. Stacked parts are fused into one print.