Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG; hose it out after use. Prints as shown on its floor, no supports.
Add a pinch of calcium powder, drop in the crickets, cap it and shake gently. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
PETG or TPU edge; print flat.
Print in a calm neutral; the lidded neck prints as one piece. Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
PETG; print a handful. Prints as shown on its floor, no supports.
PETG; drop in a stainless nut so it sinks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; matt stone-coloured filament looks most natural. Print floor-down as shown, then turn it over to use it.
PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG; use 80 grit sandpaper. Prints as shown on its floor, no supports. The added base's lid prints separately.
Print with low (10%) infill so the ring floats. Prints as shown on its floor, no supports.