Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Smooth walls help: print the walls with no texture. Prints as shown on its floor, no supports.
For large dogs, scale the cup to 110 mm across. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Size guide: about 1 cm3 per 10 g of body weight; this one holds about 600 cm3. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Sand the hole edges smooth. Print in PETG for strength. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Cut a perforated plastic sheet to rest on the ledge. Never turn reptile eggs. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports.
Wash before use. Pick a food-safe filament. Prints as shown on its floor, no supports.
Put it right next to the laptop, at the same height, with a soft cloth inside. Prints as shown on its floor, no supports.
Give the cricket a slice of carrot and an egg-box shelter; a pet-shop house cricket works. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Check with a reptile vet first. Use a fridge kept only for this, with a thermometer, and weigh the tortoise every week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.