Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Fits jars up to 45 mm across and 105 mm long; ten jars per insert. Prints as shown on its floor, no supports.
The base ring prints separately. Needs 55 mm of drawer depth. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Print the tray, the drawer and its case separately. Prints as shown on its floor, no supports. The drawer prints separately from the case. Stacked parts are fused into one print.
Empty the catch tray every few days. Print in PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Engrave in a contrasting colour by changing filament at the floor top. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.
Takes flat tins up to 90 mm across (tuna, sardines, cat food). Print upright. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Food-safe PETG; the two sides lift out for the dishwasher rack. Prints as shown on its floor, no supports.