Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Use LED tea lights only, never a flame. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Use LED candles, PLA softens with real flames. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Use an LED tealight; PLA softens with a real flame. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Use a small jar or tube inside for fresh water. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print one at 205 mm and four at 100 mm (change the width); the four small trays tile the big one, two of them flipped over. Prints as shown on its outline, no supports.
Print four. Arrange them in a square with the notches facing the middle. Prints as shown on its outline, no supports.
Print in white or clear. Slip a 25 mm glass test tube inside for the water. Prints as shown on its floor, no supports.
Print a dozen or more in two colours; flip some over to fill the gaps, as the real tiling does. Prints as shown on its outline, no supports.