Models Showcase

Slide a 125 x 160 mm sheet of 2 mm clear plastic down the slot behind the window. Hang it on the wall by the keyholes. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

They print as two separate pieces. Lay one curve above the other, then swap them over. Prints as shown on its outline, no supports.

Prints flat. The bays are 168, 105, 63, 42 and 21 mm squares. Prints as shown on its floor, no supports.

Prints as one piece with no supports. Tall gear for pens, middle for scissors and rulers, short for clips. Prints as shown on its outline, no supports.

Prints flat with no supports. The gate leads into the front room. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.

Press four 12.7 mm disc magnets into the sockets with the same pole up; slide two 12.7 mm ring magnets onto a pencil with the matching pole facing down. Prints as shown on its floor, no supports.

Print in blue or black; the corner notch is the write-protect tab. Prints as shown on its floor, no supports.

Print as many as you like; every tab fits every blank, so they join in any grid. Prints as shown on its outline, no supports.

Print in clear or smoke grey for the full cassette look. Prints as shown on its floor, no supports. Stacked parts are fused into one print.

Holes take pens and markers up to 12 mm. Prints as shown on its floor, no supports. Stacked parts are fused into one print.