Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in red or green with the word in gold; envelopes stand in three rows. Prints as shown on its floor, no supports.
Roll each belt and stand it in its bay from white on the left to black on the right. Prints as shown on its floor, no supports.
Slots take standard graded slabs about 7 mm thick. Prints as shown on its floor, no supports.
Print the lid with the moon face up; a dark purple or black filament with gold text looks best. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Pockets fit standard elongated cents up to 33 x 20 mm; print more trays and stack them. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Hang through the keyholes; each ledge takes about six thimbles. Prints as shown on its floor, no supports.
Print the heart vessel in white; fill the two cups with contrasting sand. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Uses the editor lazy-Susan base with BBs. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports.