Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Drain and hold toothbrushes upright
A round holder with four sections and a honeycomb floor that drains.
Printing notes
67.5 cm³
Volume
83.8 g
Est. weight
2,294
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep soap dry between uses
An oval soap dish with a slotted floor so the soap stays dry.
Printing notes
23.0 cm³
Volume
28.5 g
Est. weight
14,520
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store cotton pads and swabs
Two sections with a lift-off lid for cotton pads and swabs.
Printing notes
170.4 cm³
Volume
211.3 g
Est. weight
260
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Hold shower products on the wall
A caddy that hangs on two screws, with a honeycomb floor that drains.
Printing notes
37.0 cm³
Volume
45.9 g
Est. weight
4,494
Triangles
Prints as shown on its floor, no supports.