Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Store a rafter speed square
A tray with a recess shaped exactly like a 7-inch rafter square, so it always goes back in the same place.
Printing notes
439.7 cm³
Volume
545.2 g
Est. weight
1,224
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a multimeter and its probes
A deep fitted caddy for a multimeter with a long channel beside it for the test probes and leads.
Printing notes
313.4 cm³
Volume
388.7 g
Est. weight
1,772
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store wire strippers in a drawer
A thin shadow board for a tool drawer with a recess shaped like a pair of wire strippers.
Printing notes
101.2 cm³
Volume
125.5 g
Est. weight
748
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Organise a ratchet and sockets
A shadow tray with a ratchet-shaped recess and a row of four sockets in rising sizes.
Printing notes
272.0 cm³
Volume
337.3 g
Est. weight
2,716
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store small parts in a Gridfinity bin
A long Gridfinity bin with a scooped front edge for small parts and a label slot.
Printing notes
35.2 cm³
Volume
43.6 g
Est. weight
2,254
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Sweep sawdust off the workbench
A bench dustpan with an open front to sweep into, filleted inner corners and a hanging slot in the back.
Printing notes
112.5 cm³
Volume
139.6 g
Est. weight
1,260
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Catch slurry under a whetstone
The stone sits inside an inner wall while water and slurry run off into the channel around it, on small feet.
Printing notes
95.4 cm³
Volume
118.3 g
Est. weight
2,352
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hang a cordless drill on the wall
A wall holster that holds a cordless drill chuck-down through a hole in its floor, battery up and ready to grab.
Printing notes
33.0 cm³
Volume
40.9 g
Est. weight
1,664
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Catch oil drips under machines
A drop-shaped drip tray that sits under a machine, bike or oil can, with OIL engraved in the floor.
Printing notes
91.3 cm³
Volume
113.2 g
Est. weight
1,668
Triangles
Prints as shown on its outline, no supports.
MAIN PURPOSE: Hold a miniature while painting it
A comfortable handle with a round recess in the top that holds a miniature on its base while you paint.
Printing notes
22.7 cm³
Volume
28.1 g
Est. weight
1,616
Triangles
Prints as shown on its floor, no supports.