Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Magnets go in the right-hand bay away from the pins, so they don't clump together. Prints as shown on its floor, no supports.
Print two, one for each player; a wood-fill filament suits the game. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Bird-safe use: print in natural PLA, check for loose strings each week and remove if chewed sharp. Prints as shown on its floor, no supports.
Thread a 40 mm belt through the two back slots; PETG for mud and rain. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
PETG; hose it out after use. Prints as shown on its floor, no supports.
PETG; tip the drip tray out over a sink. Prints as shown on its floor, no supports.
Mount at adult height; wash the spacer as your nurse advises and let it dry in the tube. Prints as shown on its floor, no supports.
Hang at child height through the keyholes; darts stand nose-up in the rows. Prints as shown on its floor, no supports.
Scoop, shake over the sand, then move the keepers into the three side bays. Prints as shown on its floor, no supports.
Print four, one per seat; the five slots take the bid cards from 1 to 7. Prints as shown on its floor, no supports.