Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Protect a speaker cone
A perforated front grille for a home-built speaker box: the round holes let the sound through and protect the cone from fingers; screw it on through the four corner holes.
Printing notes
58.9 cm³
Volume
73.0 g
Est. weight
19,422
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Dispense six colours of hook-up wire
Six spools of hook-up wire stand in their own bays and feed out through six holes in the front, so you pull exactly the colour you need without unwinding the rest.
Printing notes
157.0 cm³
Volume
194.6 g
Est. weight
5,976
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Bend component leads to breadboard spacing
Bend resistor and diode leads to fit exactly 4 to 9 breadboard holes apart: lay the part across the step with the right number and fold both leads down over its edges.
Printing notes
10.2 cm³
Volume
12.6 g
Est. weight
6,948
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Hold a multimeter and its probes
A deep fitted caddy for a multimeter with a long channel beside it for the test probes and leads.
Printing notes
313.4 cm³
Volume
388.7 g
Est. weight
1,772
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Feed solder wire from its spool
A round canister the solder spool turns inside, feeding the wire out through a small hole in the fitted top, on round feet.
Printing notes
63.1 cm³
Volume
78.3 g
Est. weight
1,720
Triangles
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
MAIN PURPOSE: Enclose a credit-card sized computer
An enclosure for a credit-card sized computer with port openings, a slotted vent panel and a flat lid.
Printing notes
55.1 cm³
Volume
68.3 g
Est. weight
12,668
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Sort heat-shrink tubing by diameter
Six lanes that get wider from left to right, for heat-shrink tubing from the thinnest to the thickest, with a label slot.
Printing notes
98.2 cm³
Volume
121.7 g
Est. weight
1,124
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a breadboard and jumper wires
A tray with a recess for a full-size solderless breadboard, finger notches to lift it out, and a bay beside it for jumper wires.
Printing notes
169.7 cm³
Volume
210.4 g
Est. weight
1,600
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold circuit boards steady while soldering
A cradle with a groove along each side wall: slide a circuit board in from the open front and it is held flat and steady while you solder.
Printing notes
73.0 cm³
Volume
90.5 g
Est. weight
156
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Rest a soldering iron safely
A tray with a pocket shaped for a soldering iron.
Printing notes
85.3 cm³
Volume
105.7 g
Est. weight
1,456
Triangles
Prints as shown on its floor, no supports.