Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Hold RC cars with wheels free
A work stand for 1:10 RC cars: set the car on top so its wheels spin free while you tune the motor or change tyres, and carry it to the track by the hand holes. Print it as shown, then turn it over so the floor becomes the top.
Printing notes
48.3 cm³
Volume
59.9 g
Est. weight
2,324
Triangles
Print floor-down as shown, then turn it over to use it. Large holes in the walls may need supports or good bridging.
MAIN PURPOSE: Store a compact bicycle torque wrench
A long fitted case for a compact bicycle torque wrench, with a telescoping lid shown beside it.
Printing notes
374.7 cm³
Volume
464.6 g
Est. weight
5,620
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Store spare car blade fuses
Twelve small cells for blade fuses by rating, with a flat lid and ring pull for the glovebox.
Printing notes
96.6 cm³
Volume
119.8 g
Est. weight
3,408
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Trap grit below your wash mitt
A honeycomb-perforated disc on feet that sits in the bottom of a wash bucket and keeps grit away from your mitt.
Printing notes
180.4 cm³
Volume
223.7 g
Est. weight
5,516
Triangles
Prints flat as a plate, no supports.