Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Sweep sawdust off the workbench
A bench dustpan with an open front to sweep into, filleted inner corners and a hanging slot in the back.
Printing notes
112.5 cm³
Volume
139.6 g
Est. weight
1,260
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Catch slurry under a whetstone
The stone sits inside an inner wall while water and slurry run off into the channel around it, on small feet.
Printing notes
95.4 cm³
Volume
118.3 g
Est. weight
2,352
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hang a cordless drill on the wall
A wall holster that holds a cordless drill chuck-down through a hole in its floor, battery up and ready to grab.
Printing notes
33.0 cm³
Volume
40.9 g
Est. weight
1,664
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Catch oil drips under machines
A drop-shaped drip tray that sits under a machine, bike or oil can, with OIL engraved in the floor.
Printing notes
91.3 cm³
Volume
113.2 g
Est. weight
1,668
Triangles
Prints as shown on its outline, no supports.
MAIN PURPOSE: Hold a miniature while painting it
A comfortable handle with a round recess in the top that holds a miniature on its base while you paint.
Printing notes
22.7 cm³
Volume
28.1 g
Est. weight
1,616
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a breadboard and jumper wires
A tray with a recess for a full-size solderless breadboard, finger notches to lift it out, and a bay beside it for jumper wires.
Printing notes
169.7 cm³
Volume
210.4 g
Est. weight
1,600
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store spudgers, picks and pry tools
A shadow tray for four spudgers, picks and pry tools, with a finger channel across the middle.
Printing notes
114.0 cm³
Volume
141.3 g
Est. weight
2,208
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Spread glue in an even film
A stiff spreader card with fine teeth along one edge for an even film of wood glue or tile adhesive.
Printing notes
9.2 cm³
Volume
11.4 g
Est. weight
636
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Protect a pull saw's teeth
A slim channel that slides over the teeth of a Japanese pull saw, so the blade stays sharp and fingers stay safe in the toolbox.
Printing notes
8.1 cm³
Volume
10.0 g
Est. weight
96
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Tear sandpaper into sander-sized strips
Lay it on a standard sheet with the lip hooked over the edge and tear upwards along the plate for a perfect one-third strip that fits a palm sander. Print it as shown, then turn it over so the floor becomes the top.
Printing notes
69.2 cm³
Volume
85.8 g
Est. weight
48
Triangles
Print floor-down as shown, then turn it over to use it.