Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in PETG or TPU so the clip flexes. Prints flat as a plate, no supports.
Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Print with low (10%) infill so the ring floats. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print flange-down; no supports. Prints flat as a plate, no supports. Stacked parts are fused into one print.