Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Large print: about 240 mm square. Print in white for the brightest light. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints flat as a plate, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print floor-down (the floor is the hood's roof), no supports. Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.