Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
TPU 95A; scale the ring to your lens. Prints as shown on its outline, no supports.
Load the base with 6 mm BBs. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The turntable ring prints separately and runs on 6 mm BBs.
Matt black PLA; size the cap to your lens barrel. Prints as shown on its floor, no supports.
Measure your timer first; keep the payload light. Print floor-down as shown, then turn it over to use it.
Prints flat as a plate, no supports.
Print two, profile on the bed, in PETG. Prints as shown on its outline, no supports.
Matt black PLA; tape the lid seam against light leaks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports.