Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG; use 80 grit sandpaper. Prints as shown on its floor, no supports. The added base's lid prints separately.
Print with low (10%) infill so the ring floats. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
Print lying on its side, or as it comes. Prints as shown on its floor, no supports.
Print in PETG and rinse well before it goes in the tank. Print floor-down as shown, then turn it over to use it. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.