Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Put it right next to the laptop, at the same height, with a soft cloth inside. Prints as shown on its floor, no supports.
Give the cricket a slice of carrot and an egg-box shelter; a pet-shop house cricket works. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Check with a reptile vet first. Use a fridge kept only for this, with a thermometer, and weigh the tortoise every week. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Let the dog watch you load it the first few times; supervise and put it away after play. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Cut corrugated cardboard into 40 mm strips and stand them on edge, packed tight; flip them when worn. Prints as shown on its floor, no supports.
Fill the box with fleece strips and scatter kibble; the deck makes the dog work with its nose. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Hang it inside the tank rim; the slots let water flow but keep adult fish out. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Screw it to the coop wall at back height; fill the left side with grit, the right with crushed oyster shell. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Weight the base with a few coins if your wands are long. Prints as shown on its floor, no supports. The added base's lid prints separately.
Thread a belt or the lead's waist strap through the back slots. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.