Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Store a rock and mineral collection
Sixteen cells for a growing rock, mineral or fossil collection, with a telescoping lid shown beside it.
Printing notes
210.8 cm³
Volume
261.4 g
Est. weight
4,980
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Display a signed ball on shelves
A scalloped ring that holds a football, basketball or signed ball still on a shelf.
Printing notes
30.3 cm³
Volume
37.6 g
Est. weight
1,148
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Display keepsakes behind glass
A deep display frame for keepsakes: the glass from a 6 x 8 inch photo frame slides into grooves along three sides from the low top edge, and it hangs from two nail holes.
Printing notes
97.1 cm³
Volume
120.4 g
Est. weight
508
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Display an enamel pin collection
A perforated board for enamel pin collections: push the pins through any of the holes and fit the backs behind; hangs on two nails through the holes.
Printing notes
103.9 cm³
Volume
128.8 g
Est. weight
19,612
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Store a coin collection in sixteen cells
Sixteen cells for coins with a telescoping lid.
Printing notes
166.8 cm³
Volume
206.8 g
Est. weight
256
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Display an antique key in a tray
A tray with a pocket shaped for an antique key.
Printing notes
58.9 cm³
Volume
73.0 g
Est. weight
1,784
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Display minifigures and small collectibles
Twelve cells for minifigures and small collectibles with a lift-off lid.
Printing notes
424.1 cm³
Volume
525.9 g
Est. weight
308
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Sort coins into four sections
A round coin box with four sections and a press-on lid.
Printing notes
64.6 cm³
Volume
80.1 g
Est. weight
1,600
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.