Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Close open handlebar ends
Push-in end caps for 22 mm bicycle handlebars, replacing lost originals: an open bar end can cut like a punch in a fall.
Printing notes
4.0 cm³
Volume
5.0 g
Est. weight
1,360
Triangles
Print two in PETG or TPU. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
MAIN PURPOSE: Keep glasses handy in the car
Clips onto a car sun visor and holds sunglasses or reading glasses by one arm, always within reach and never sliding about on the dashboard.
Printing notes
10.1 cm³
Volume
12.5 g
Est. weight
568
Triangles
Print lying flat in PETG or ASA.
MAIN PURPOSE: Scrape ice off car windscreens
A flat ice scraper with a wide blade for windscreens and a long, narrow handle that keeps your knuckles off the glass; print it in PETG so it stays tough in the cold.
Printing notes
42.4 cm³
Volume
52.6 g
Est. weight
1,444
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Remove bike tyres from rims
A stiff tyre lever with a spoon tip that slides under the bead and a hooked tail that clips onto a spoke; print two or three in PETG or nylon for the saddle bag.
Printing notes
12.5 cm³
Volume
15.4 g
Est. weight
252
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Carry a bike multitool and levers
A fitted case for a folding bike multitool and two tyre levers, with a telescoping lid shown beside it.
Printing notes
175.9 cm³
Volume
218.1 g
Est. weight
5,728
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Carry bike puncture repair supplies
Three bays for patches, glue and sandpaper in a tin that fits a saddle bag, with PUNCTURE KIT on the telescoping lid.
Printing notes
44.7 cm³
Volume
55.4 g
Est. weight
8,516
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Hold coins and keys in the cupholder
A round insert for a car cup holder, split for coins and keys.
Printing notes
45.6 cm³
Volume
56.6 g
Est. weight
704
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store small items between seat and console
A slim organizer that slides between the seat and the console.
Printing notes
42.1 cm³
Volume
52.2 g
Est. weight
132
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Sort items in a car door pocket
A two-bay bin for the car door pocket.
Printing notes
42.5 cm³
Volume
52.7 g
Est. weight
120
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Organise the car trunk in three bays
A big three-bay trunk organizer with carry notches.
Printing notes
238.4 cm³
Volume
295.6 g
Est. weight
284
Triangles
Prints as shown on its floor, no supports.