Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the height, the diameter or the curve in the editor, or add a wall pattern, to make your own.
Silk or gradient PLA makes the plain curve glow. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the curve in the editor, or add a wall pattern, to make your own.
Silk, marble or matte PLA all look good on the smooth surface; it prints quickly and uses little filament. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Line the inside of the curve with kitchen foil or aluminium tape, then stand the router's antenna up through the hole at the focus. Prints as shown on its outline, no supports.
Slide a 125 x 160 mm sheet of 2 mm clear plastic down the slot behind the window. Hang it on the wall by the keyholes. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints flat with no supports. The gate leads into the front room. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print it in black and lay it on a white desk; the faces appear in the white space either side. Prints as shown on its outline, no supports.
Print as many as you like; every tab fits every blank, so they join in any grid. Prints as shown on its outline, no supports.
Lay the charging cable through the back port to the glasses' hinge connector. Prints as shown on its floor, no supports.
Print in a bold colour; the loops make natural pockets for keys and coins. Prints as shown on its outline, no supports.