Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print some bins mirrored: the hat tiling uses both hands. Prints as shown on its outline, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
They print as two separate pieces. Lay one curve above the other, then swap them over. Prints as shown on its outline, no supports.
Press four 12.7 mm disc magnets into the sockets with the same pole up; slide two 12.7 mm ring magnets onto a pencil with the matching pole facing down. Prints as shown on its floor, no supports.
Print in blue or black; the corner notch is the write-protect tab. Prints as shown on its floor, no supports.
The phone stands inside on its side, filling the screen; the cable leaves through the back. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.