Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Stand razors and shavers to drain
A two-slot stand with a honeycomb floor that lets water drain.
Printing notes
18.8 cm³
Volume
23.3 g
Est. weight
2,196
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store cufflinks and tie clips
Eight small pockets with a telescoping lid for cufflinks and tie clips.
Printing notes
92.8 cm³
Volume
115.1 g
Est. weight
328
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Hang a hair dryer and straightener
Two deep pockets for a hair dryer and straightener that hang on the wall.
Printing notes
45.1 cm³
Volume
55.9 g
Est. weight
624
Triangles
Prints as shown on its floor, no supports.