Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Squeeze every last bit of toothpaste
Thread the end of the tube through the slot and slide the squeezer up to push out every last bit, with side cheeks to grip.
Printing notes
4.0 cm³
Volume
5.0 g
Est. weight
744
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Display rolled washcloths and face towels
Rolled washcloths and face towels in three bays under a dust hood with an open front, the way a spa displays them.
Printing notes
254.7 cm³
Volume
315.9 g
Est. weight
5,072
Triangles
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
MAIN PURPOSE: Catch hair over the shower drain
A perforated cup that sits on small feet over the shower drain: water runs through and hair stays behind for easy emptying.
Printing notes
10.8 cm³
Volume
13.4 g
Est. weight
5,432
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Drain and hold a bar of soap
A wall-mounted soap dish with drain holes and two keyholes.
Printing notes
20.2 cm³
Volume
25.1 g
Est. weight
2,000
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep soap dry on the wall
A wall soap shelf with an open honeycomb floor on two keyholes.
Printing notes
17.9 cm³
Volume
22.2 g
Est. weight
4,990
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold two soaps over drain floors
Two soap bays with honeycomb drain floors on two keyholes.
Printing notes
37.6 cm³
Volume
46.6 g
Est. weight
4,118
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hang a bidet sprayer on the wall
A wall holder for a bidet sprayer with a low front for the hose, on two keyholes.
Printing notes
8.3 cm³
Volume
10.3 g
Est. weight
1,496
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a bidet sprayer in a cup
A deeper wall cup with a hose notch in the front, on two keyholes.
Printing notes
10.0 cm³
Volume
12.4 g
Est. weight
1,572
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold four toothbrushes over a drip floor
Four toothbrush bays over a honeycomb drip floor.
Printing notes
51.9 cm³
Volume
64.4 g
Est. weight
3,358
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hang toothbrushes and a rinse cup
A wall holder for toothbrushes with a round cup joined to the side, on two keyholes.
Printing notes
114.4 cm³
Volume
141.9 g
Est. weight
1,316
Triangles
Prints as shown on its floor, no supports.