Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Prints as shown on its floor, no supports. The 3 drawers print separately from the case.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The 4 drawers print separately from the case.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.