Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints as shown on its floor, no supports.
Print flat; check the bearing fit on the centre hole first and scale slightly if it is too tight.
Prints as shown on its floor, no supports.
Print a set in several colours. Prints as shown on its floor, no supports.
Print in a translucent filament so the map shows through. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.