Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Make a skipping rope
Turn any 6-10 mm rope into a skipping rope: thread each end through a handle, tie a knot and pull it back inside; the round grips spin freely in the hand.
Printing notes
25.8 cm³
Volume
32.0 g
Est. weight
848
Triangles
Print two. Prints as shown on its floor, no supports.
MAIN PURPOSE: Hold a ball for place kicks
Holds a rugby or American football upright for place kicks on grass or artificial turf: the ball rests in the ring at the right height and angle.
Printing notes
64.9 cm³
Volume
80.5 g
Est. weight
1,008
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Repair pitch marks on golf greens
Repairs pitch marks on the green: push the two prongs in round the mark, lever the turf towards the centre and tap it flat with the grip.
Printing notes
7.0 cm³
Volume
8.6 g
Est. weight
364
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Carry cue chalk
Keeps a cube of cue chalk on your keyring or belt loop between shots, so it never goes missing from the table edge.
Printing notes
1.7 cm³
Volume
2.1 g
Est. weight
2,170
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Throw a disc at the park
A lightweight flying disc for the beach or the park: the rounded rim makes it comfortable to catch and the shallow cup shape keeps it steady in flight. Throw it with the flat side up.
Printing notes
115.6 cm³
Volume
143.4 g
Est. weight
680
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Protect three steel-tip darts
A fitted case for three steel-tip darts, flights on, with a telescoping lid shown beside it.
Printing notes
226.6 cm³
Volume
281.0 g
Est. weight
5,312
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Protect a table tennis bat
A fitted case for a table tennis bat, with a telescoping lid shown beside it.
Printing notes
504.8 cm³
Volume
626.0 g
Est. weight
5,624
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Sort golf balls, tees and markers
Twelve cells for golf balls, tees and markers with a finger notch.
Printing notes
118.2 cm³
Volume
146.6 g
Est. weight
244
Triangles
Prints as shown on its floor, no supports.