Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print six; glue the lids once filled. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Print in PETG. Prints flat as a plate, no supports.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print with 3 walls and no gaps so it stays watertight. Prints as shown on its outline, no supports.
Prints as shown on its floor, no supports.
Check the marks against a ruler for your printer and the shoe brand. Prints flat as a plate, no supports.
Prints flat as a plate, no supports.
Print in PETG or ASA, which stays tough in the cold. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.