Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Hold circuit boards steady while soldering
A cradle with a groove along each side wall: slide a circuit board in from the open front and it is held flat and steady while you solder.
Printing notes
73.0 cm³
Volume
90.5 g
Est. weight
156
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Rest a soldering iron safely
A tray with a pocket shaped for a soldering iron.
Printing notes
85.3 cm³
Volume
105.7 g
Est. weight
1,456
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Sort electrical connectors and terminals
Sixteen cells for connectors and terminals with a lid.
Printing notes
264.3 cm³
Volume
327.7 g
Est. weight
256
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Sort resistors, LEDs and connectors
Twelve compartments for resistors, LEDs and connectors with a bar-handled lid and rounded corners.
Printing notes
342.4 cm³
Volume
424.5 g
Est. weight
3,028
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Hold solder, flux and iron cleaner
A tray for solder, flux and tips with a holder for the iron cleaner on the side.
Printing notes
90.6 cm³
Volume
112.3 g
Est. weight
788
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store resistors, LEDs and small components
A cabinet with four drawers for resistors, LEDs and small parts.
Printing notes
243.2 cm³
Volume
301.6 g
Est. weight
180
Triangles
Prints as shown on its floor, no supports. The 4 drawers print separately from the case.