Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Spin tea flavours to the front
A nine-cell tea chest on a Lazy Susan base with a telescoping lid, so every flavour turns to the front.
Printing notes
678.5 cm³
Volume
841.4 g
Est. weight
5,348
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The turntable ring prints separately and runs on 6 mm BBs.
MAIN PURPOSE: Sort tea bags into labelled lanes
Five tea lanes with a label slot, a finger notch and soft rounded rims.
Printing notes
153.3 cm³
Volume
190.1 g
Est. weight
1,720
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep coffee beans fresh
A tall round canister with a screw-on lid and knob to keep coffee beans fresh.
Printing notes
147.4 cm³
Volume
182.8 g
Est. weight
2,420
Triangles
Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
MAIN PURPOSE: Store tea bags in upright rows
Four upright rows for tea bags, a lift-off lid with a knob and TEA on the front.
Printing notes
225.8 cm³
Volume
280.0 g
Est. weight
536
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
MAIN PURPOSE: Keep coffee capsules in a drawer
Sixteen pockets that hold coffee capsules standing up in a drawer.
Printing notes
121.0 cm³
Volume
150.1 g
Est. weight
180
Triangles
Prints as shown on its floor, no supports.