Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG with 3 walls; keep 2 cm of water in the chamber. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
PETG, 1.6 mm, so it flexes; thread a cord or a dressing gown belt. Prints flat as a plate, no supports.
PETG; measure your knob, the cup is 56 mm inside. Prints as shown on its floor, no supports.
Matt black filament gives the best contrast. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Fits bottles up to 24 mm across. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print upside down, cup rim on the bed; the floor bridges 56 mm. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print in TPU 95A. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.