Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print flat in PETG at 100% infill.
PETG releases cured epoxy well; PLA does not. Prints as shown on its floor, no supports.
Prints as shown on its outline, no supports.
Prints as shown on its floor, no supports.
Print two in TPU or PETG. Print floor-down as shown, then turn it over to use it.
Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print as it comes, side outline on the bed; lay it down to use it.
Print in PETG with 4 walls so the fingers flex without snapping. Prints as shown on its outline, no supports.
Print as it comes; lay it on its long edge beside the stone.