Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Glue in 2 mm and 3 mm glass beads. Prints flat as a plate, no supports.
PETG, 3 walls; push a short drinking straw into the spout. Prints as shown on its floor, no supports.
White PLA, colour it with markers. Prints as shown on its floor, no supports.
PETG; print a handful. Prints as shown on its floor, no supports.
PETG; drop in a stainless nut so it sinks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; matt stone-coloured filament looks most natural. Print floor-down as shown, then turn it over to use it.
PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG; use 80 grit sandpaper. Prints as shown on its floor, no supports. The added base's lid prints separately.
Print the plate on the bed, the post upright. Print floor-down as shown, then turn it over to use it.
Print six or more. Prints as shown on its floor, no supports.