Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
TPU 95A grips best. Print two. Prints flat as a plate, no supports.
TPU 95A, 15 % gyroid infill. Print four. Prints as shown on its outline, no supports.
PETG for spring; print two. Prints as shown on its outline, no supports.
PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PLA or PETG; add a 200 mm gum-rubber disc. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG; add a strip of bike inner tube as the pad. Prints as shown on its outline, no supports.
Tie a 60 cm cord through the centre hole. Prints flat as a plate, no supports.
PETG with solid walls so it holds water; check the inside is 100 mm. Prints as shown on its floor, no supports.
Use an 8 mm dowel through the hub as the handle. Prints as shown on its floor, no supports.
White PLA for the screen wall; cap the finder scope. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.