Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG, 100 % infill. Prints flat as a plate, no supports.
Matt black PLA. Check your flash head size (here 77 x 47 mm). Prints as shown on its floor, no supports. Stacked parts are fused into one print.
TPU 95A; scale the ring to your lens. Prints as shown on its outline, no supports.
Load the base with 6 mm BBs. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The turntable ring prints separately and runs on 6 mm BBs.
Matt black PLA; size the cap to your lens barrel. Prints as shown on its floor, no supports.
Measure your timer first; keep the payload light. Print floor-down as shown, then turn it over to use it.
Prints flat as a plate, no supports.
Print two, profile on the bed, in PETG. Prints as shown on its outline, no supports.
Matt black PLA; tape the lid seam against light leaks. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG so the pipes stay airtight; 3 walls. Prints as shown on its floor, no supports.