Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print a set per player in their colour. Print floor-down as shown, then turn it over to use it.
Check the bore against your laser pointer. Prints as shown on its floor, no supports.
Print two. Prints as shown on its floor, no supports.
Print one per player. Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Print in a dark colour. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Add 60 cm of cord and two 15 mm beads. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Add 2 mm wire, a buzzer, a 5 mm LED and 2 AA cells. Print floor-down as shown, then turn it over to use it. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.