Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG with solid walls so it holds water; check the inside is 100 mm. Prints as shown on its floor, no supports.
Use an 8 mm dowel through the hub as the handle. Prints as shown on its floor, no supports.
White PLA for the screen wall; cap the finder scope. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Glue in 2 mm and 3 mm glass beads. Prints flat as a plate, no supports.
PETG, 3 walls; push a short drinking straw into the spout. Prints as shown on its floor, no supports.
White PLA, colour it with markers. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.