Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Wrap the post in mirror film; draw on a printed polar grid laid on the board. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Drop toy bones in, pour plaster with a little sand, leave 24 hours, then lift the block out by the lid and dig with a brush. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holes take 16 mm test tubes; the lower tray catches spills. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Keep a separate scoop in each bay; one stray coarse grain scratches a whole polish batch. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Lay half black and half white paper in each bay, cap gills-down across the join, lid on overnight. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Matt light filament shows the spot best. Marks set for about 51 degrees north. Prints as shown on its floor, no supports.
Measure your vial; set the inner size 2 mm larger. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print as it comes (profile on the bed); legs come out solid.
Print as it comes (profile on the bed), 100 % solid.
Print nine, open side up, same settings for equal weight. Prints as shown on its outline, no supports.