Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print as it comes (profile on the bed) in PETG.
Add one 10 x 3 mm magnet and two small screws. Prints as shown on its floor, no supports.
Print solid (100% infill) in PETG. Prints flat as a plate, no supports.
Print in ASA or PETG. Prints as shown on its floor, no supports.
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Drill with the hammer action off; bits up to 12 mm. Prints as shown on its floor, no supports.
Print standing in ASA or PETG; it is used upside down. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Print two in PETG. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flange-down; no supports. Prints flat as a plate, no supports. Stacked parts are fused into one print.