Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Hold a matcha whisk and scoop
A fitted tray for a bamboo matcha whisk and its long scoop, with a finger channel between them.
Printing notes
284.4 cm³
Volume
352.7 g
Est. weight
3,348
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Keep mixer beaters and hooks together
A fitted drawer tray that keeps a hand mixer's two beaters and two dough hooks together in matched pairs.
Printing notes
297.5 cm³
Volume
368.9 g
Est. weight
4,596
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Dust a cocoa heart on cappuccino
Hold the paddle over a cappuccino and dust cocoa through it for a heart on the foam.
Printing notes
7.7 cm³
Volume
9.5 g
Est. weight
384
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Dispense paper cups from a clean stack
A tall round tube that keeps a stack of paper cups clean and upright, with CUPS raised on the side.
Printing notes
102.4 cm³
Volume
127.0 g
Est. weight
4,836
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Stack cups by the water dispenser
A tall hexagon tower for stacking plastic or paper cups by the water dispenser.
Printing notes
111.5 cm³
Volume
138.2 g
Est. weight
68
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Separate reusable and paper straws
A tall round straw holder split in two: reusable straws one side, paper straws the other.
Printing notes
92.4 cm³
Volume
114.5 g
Est. weight
704
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Sort straws, chopsticks and cocktail sticks
A six-section hexagon holder for straws, chopsticks and cocktail sticks.
Printing notes
141.2 cm³
Volume
175.1 g
Est. weight
140
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Hide a tissue box on the counter
A tissue box cover with a pull slot and rounded corners. Print it as shown, then flip it over: the slot ends up on top.
Printing notes
59.2 cm³
Volume
73.5 g
Est. weight
1,652
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Dispense tissues from a cube cover
A cube tissue cover with an oval pull slot and soft rounded corners. Print it as shown, then flip it over: the slot ends up on top.
Printing notes
32.1 cm³
Volume
39.9 g
Est. weight
1,654
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Store snacks in a labelled pantry bin
A deep snack bin with a label slot, a finger notch and soft rounded rims.
Printing notes
72.1 cm³
Volume
89.4 g
Est. weight
2,556
Triangles
Prints as shown on its floor, no supports.