Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in clear or smoke grey for the full cassette look. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
The slot fits handhelds up to 30 mm thick; feed the USB-C cable up through the back port. Prints as shown on its floor, no supports.
Fits standard cash envelopes about 175 x 90 mm; label the bays with the front slot. Prints as shown on its floor, no supports.
Print in blue-grey or a silk filament. Prints as shown on its floor, no supports.
Print in a paper-coloured matt PLA; the slot side is the top. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print upright in PLA or PETG. Prints as shown on its floor, no supports.
Print flat in PLA. Prints as shown on its floor, no supports.
Print flat in two colours if you can. Prints as shown on its floor, no supports.
Print in PETG; one 4.5 mm wood screw and a washer. Prints as shown on its floor, no supports.
Twelve 6 x 3 mm magnets. Prints as shown on its floor, no supports.