Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Magnets go in the right-hand bay away from the pins, so they don't clump together. Prints as shown on its floor, no supports.
Print upright; pause before the foot is closed to add sand for weight. Prints as shown on its outline, no supports. Stacked parts are fused into one print.
Print as shown (profile on the bed); the rib is solid. Prints as shown on its outline, no supports.
Print as shown (profile on the bed); the rib is solid. Prints as shown on its outline, no supports.
PETG, 1.6 mm; print two per pair. Prints flat as a plate, no supports.
Print flat in PETG; add a 60 cm ribbon.
Print flat in PETG; white or clear hides best.
Print with 4 walls so the post stays stiff. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Prints as shown on its floor, no supports.
Print flat in PETG.