Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Prints in one piece with no supports. Change the height, the belly or the neck in the editor to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
The legs print separately and press into holes under the bowl, so every part prints flat with no supports. Change the size or the facet size in the editor to make your own.
Print the three legs separately and press them into the holes underneath; a drop of glue makes them permanent. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor to make your own.
Silk or gradient PLA shows off the facets. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the diameter or the facet size in the editor to make your own.
Silk or translucent filament makes the facets sparkle. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the curve or the facet size in the editor to make your own.
Silk or glossy PLA makes every facet flash in the light; 3 walls keep the facets solid. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the belly or the neck in the editor, or add a wall pattern, to make your own.
Slow the print down for the slim neck, or print two at once, so each small layer can cool. For fresh flowers, print in PETG or slip a glass test tube into the neck. Prints as shown on its floor, no supports.
The legs print separately and press into holes under the bowl, so every part prints flat with no supports. Change the size in the editor, or add a wall pattern, to make your own.
Print the three legs separately and press them into the holes underneath; a drop of glue makes them permanent. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size, the belly or the neck in the editor, or add a wall pattern, to make your own.
Matte terracotta or stone-effect PLA makes it look like real pottery. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the height, the diameter or the curve in the editor, or add a wall pattern, to make your own.
Silk or gradient PLA makes the plain curve glow. For fresh flowers in water, print in PETG or stand a glass inside. Prints as shown on its floor, no supports.
Prints in one piece with no supports. Change the size or the curve in the editor, or add a wall pattern, to make your own.
Silk, marble or matte PLA all look good on the smooth surface; it prints quickly and uses little filament. Prints as shown on its floor, no supports.