Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print flange-down; no supports. Prints flat as a plate, no supports. Stacked parts are fused into one print.
Print floor-down as shown, then turn it over to use it.
Print lying flat so the layers run along the hook; PETG holds better than PLA.
Print as it comes (wedge outline on the bed); PETG or TPU grips floors best.
Print floor-down as shown, then turn it over to use it.
Prints as shown on its floor, no supports.
Print floor-down as shown, then turn it over to use it.
Print in ASA or PETG for outdoor use. Print floor-down as shown, then turn it over to use it.
Print in PETG so it springs round the pipe. Print floor-down as shown, then turn it over to use it.
Print as it comes (ramp outline on the bed); print two side by side for a wide door.