Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw the column onto the stud in the bottom tray, screw the top tray on, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Every part prints flat with no supports. Screw each column onto the stud in the tray below, screw the next tray on top, and push the pedestal peg up into the bottom tray. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Glue two 30 mm, 5x lenses over the eye ports; print stereo pairs 63 mm apart on card and slip them in the back slot. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in blue or black; the corner notch is the write-protect tab. Prints as shown on its floor, no supports.