Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Mark where a picture hook must go
Hang the picture's wire or cord in the notch, push a panel pin through the hole just below it, then hold the picture where it should go and press: the pin pricks the exact spot for the hook, so the picture hangs where you held it, first time, with no measuring.
Printing notes
11.2 cm³
Volume
13.9 g
Est. weight
288
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Catch oil drips under machines
A drop-shaped drip tray that sits under a machine, bike or oil can, with OIL engraved in the floor.
Printing notes
91.3 cm³
Volume
113.2 g
Est. weight
1,668
Triangles
Prints as shown on its outline, no supports.
MAIN PURPOSE: Sort tiny watch parts in bays
A round tray with eight bays around a centre cup for the tiny parts of a watch, with a screw-on lid.
Printing notes
76.9 cm³
Volume
95.4 g
Est. weight
3,196
Triangles
Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.