Showcase
Models Showcase
Models shared by the SO3D.xyz community. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Organise a uniform pocket
Drops into a scrubs or tunic pocket and keeps pens, a penlight, scissors and tape upright in their own slots, so nothing falls out when you bend down.
Printing notes
14.0 cm³
Volume
17.3 g
Est. weight
1,028
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Dispense ribbon from reels
Dispenses up to three ribbon reels for a florist or gift-wrapping table: slide a rod through the side holes and the reels, and pull each ribbon out through its front slot.
Printing notes
46.0 cm³
Volume
57.0 g
Est. weight
3,284
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Let pupils leave the classroom with a pass
A tough hall pass for school corridors: hang it on a lanyard through the hole, and the class name goes in the raised text.
Printing notes
31.1 cm³
Volume
38.6 g
Est. weight
8,792
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Candle eggs during incubation
Check hatching eggs for growth: slip the cup over a small torch or a phone light, rest the egg on the soft rim and look for veins and movement in a dark room.
Printing notes
16.5 cm³
Volume
20.4 g
Est. weight
848
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Support work for jewellery sawing and filing
Clamp it to the bench edge to support silver sheet and wire while you saw, file and drill; the V cut-out lets the saw blade pass right through.
Printing notes
44.4 cm³
Volume
55.0 g
Est. weight
476
Triangles
Prints as shown on its outline, no supports.
MAIN PURPOSE: Keep opened sealant tubes from drying out
Push one onto a cut caulk or sealant nozzle and the tube stays usable for weeks instead of curing solid.
Printing notes
1.6 cm³
Volume
2.0 g
Est. weight
680
Triangles
Print a handful; TPU seals best. Prints as shown on its floor, no supports.
MAIN PURPOSE: Smooth a step at a door threshold
A low ramp for a door threshold up to 22 mm high, so robot vacuums, wheeled bins and walkers roll over instead of getting stuck.
Printing notes
185.2 cm³
Volume
229.6 g
Est. weight
260
Triangles
Print as it comes (ramp outline on the bed); print two side by side for a wide door.
MAIN PURPOSE: Display sports medals
Display race and sports medals on the wall: thread each ribbon through a slot so the medals hang in a row under the engraved word.
Printing notes
67.0 cm³
Volume
83.1 g
Est. weight
12,690
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Store vacuum attachments on the wall
Screw the plate to the wall beside a stick vacuum and park its crevice tool, brush and extension on the three pegs. Print it lying flat; on the wall the pegs point straight out.
Printing notes
144.9 cm³
Volume
179.6 g
Est. weight
3,028
Triangles
Prints flat as a plate, no supports.
MAIN PURPOSE: Protect floors under casters
Stops chair and sofa casters rolling and scratching wooden floors: the wheel sits in the inner ring and the grip feet hold the cup still.
Printing notes
20.5 cm³
Volume
25.4 g
Est. weight
1,168
Triangles
Print four in TPU or PETG. Prints as shown on its floor, no supports.